System information

67 of 114Release 7.0VNX™ System Operations
Audit the VNX
Starting with version 6.0 of teh software, the Control Station provides greater
system auditing capabilities than were previously available. VNX auditing now
provides a method to audit/detect access to the Data Mover file systems from the
Control Station.
Auditing is enabled by default on the Control Station after a fresh install, a Control
Station recovery, and an upgrade from 5.5 to 6.0. When upgrading from 5.6 or later,
the audit state (enabled or disabled) and any associated audit configuration and
rules will be preserved.
Verify if auditing is enabled, by:
Note: For more information about configuring VNX auditing, refer to Auditing the Control
Station technical note.
Step Action Output
1. Log in to the server as root.
2. To check if auditing in running on the
Control Station, type:
# /sbin/service auditd status
auditd (/spid 13367) is
running...
Note: If auditing is not running, the CS will
display:
auditd is stopped