System information

VNX™ System Operations78 of 114 Release 7.0
Manual instructions for setting the country code
Procedure to manually set the country or region code without ZBAWizard.exe:
Step Action
1. Connect the serial cable from the modem to your service laptop.
Note: Ensure that the modem is powered on.
2. Open a HyperTerminal session by using the following settings: 19200 bits per second, 8
data bits, parity None, 1 stop bit, flow control None. Set terminal emulation to ANSI.
Typically this is done by using COM 1.
3. Type the following command to check the current country or regional setting:
ATI9
9
The decimal value associated with the country or region code is output to the
HyperTerminal session. Table 2 on page 79 details the list of countries and their decimal
values.
For example:
+++
+ ATI9
952
2(?$MTS00C1\\MODEM\TIA0602,TIA0578\MultiTech Systems MT5634ZBA-
V92A9)
OK
4.
If the country or region code needs to be changed, type the following command:
AT%T19,0,<modem_hex_value>
where:
<modem_hex_value> is the hex value for the country or region code. Table 2 on page 79
provides more information.
For example:
AT%T19,0,1
1OK
5. Type the following command to confirm that the current country or regional setting was
changed correctly:
ATI9
The decimal value associated with the country or region code is output to the
HyperTerminal session. Table 2 on page 79 details the list of countries and their decimal
values.
This completes the procedure.