System information

VNX™ System Operations8 of 114 Release 7.0
Managing the VNX
The tasks to manage the VNX are:
◆ "Power up the VNX" on page 9
◆ "Power down the VNX" on page 26
◆ "Shut down the VNX in an emergency" on page 44
◆ "Power up after an emergency shutdown" on page 45
◆ "Halt the Control Station" on page 46
◆ "Restart the Control Station" on page 48
◆ "Halt the Data Movers" on page 51
◆ "Restart a Data Mover" on page 52
◆ "Check the system status" on page 53
◆ "Back up the VNX database" on page 55
◆ "Verify the daemons" on page 58
◆ "Discover SCSI devices" on page 59
◆ "Save SCSI devices" on page 60
◆ "Identify the software versions" on page 61
◆ "Set the time zone of the VNX" on page 62
◆ "Configure NTP service using the CLI" on page 64
◆ "Set the date and time of the VNX" on page 66
◆ "Audit the VNX" on page 67
◆ "Configure IP aliasing" on page 69
◆ "Configure SNMP" on page 71
◆ "Change the ConnectHome settings" on page 72
◆ "Set the country code on the MT5634ZBA modem" on page 75
◆ "Manual instructions for setting the country code" on page 78
◆ "Change the Control Station hostname" on page 82
◆ "Install Control Station Linux security alerts" on page 85
◆ "Avoid private LAN IP address conflicts" on page 86
◆ "Change VNX for block SP management port IP addresses" on page 87
◆ "Interpret log files" on page 88
◆ "NAS or SAN environment rules" on page 94
◆ "Collect problem information" on page 97
◆ "Troubleshooting" on page 104