Installation Guide
3
INSTALLATION
PREPARATION
2
a
b
1. Most homeowners prefer to have the storm
door handle on the same side as the entry
door handle. In shallow door openings,
this can cause the two handles to interfere.
Check for potential interference using the
rough measurements. If you anticipate
that there will be interference, hand the
storm door on the opposite side of your
FOUSZEPPS4FFQBHF'JHVSFGPSEFUBJMFE
hardware depth requirements.
In this step you will determine the handle side of your storm door.
1. Left Handed (Figure 4): From the exterior, a left handed storm door will have the handle on the
MFGUTJEFPGUIFTUPSNEPPS4FFQBHFTGPSJOTUBMMBUJPOJOTUSVDUJPOT
2. Right Handed (Figure 5): From the exterior, a right handed storm door will have the handle on
UIFSJHIUTJEFPGUIFTUPSNEPPS4FFQBHFTGPSJOTUBMMBUJPOJOTUSVDUJPOT
3. The interior side is where ventilating glass panel latches are located. (Figure 6).
Figure 4 Figure 5
2 1/2”
40 1/2”
LEFT HANDED
A LA IZQUIERDA
À MAIN GAUCHE
RIGHT HANDED
A LA DERECHA
À MAIN DROITE
X
VIEW
Figure 6
i
VIEW
TO DOOR SILL
HASTA EL BATIENTE DE LA PUERTA
JUSQU’AU SEUIL DE LA PORTE
J
Determine if shimming
is needed
1.
Use the table above to determine if you need to use a shim.
2. If your opening width falls within the dimensions listed, you will need to install BwUIJDLshim.
If your opening width does not fall within these dimensions, proceed to step 3.
c
X
VIEW
Nominal Storm
Shim needed if
opening width is:
Door Sizes
wYwwYw w50w
wYw w50w
wYw w50w
wYwwYw w50w
wYwwYw w50w