Installation Guide

7
BOTTOM
PARTE INFERIOR
BAS
1.
Install the door sweep (G) so that it is
centered across the width of the door frame
and pressed tight against the bottom of the
door frame.
2. $FOUFSQVODIBOEUIFOQSFESJMMwQJMPU
holes at the bottom of the slot for future
adjustment, then attach the sweep using
QBJOUFEwTDSFXTGSPNUIFQJOLCBH
PREPARE
STORM
DOOR FOR
INSTALLATION
(Right Hand)
7
c
For a Left Hand Installation, go to Page 4.
1.
Place latch side edge of door frame on the
ground. TIP: Lay on door carton.
2. Identify the top of the hinge rail (D).
3. 3FNPWFUIFOEBOESETDSFXGSPNUIFUPQPO
the hinge side edge of door frame.
1. Position the hinge rail along the hinge-side
edge of the door frame so the bottom
IPMFPGUIFOEIJOHFVQGSPNUIF
bottom lines up with the bottom hole
from the screw removed in step 7a.
NOTE: The top of the hinge rail should
FYUFOEBQQSPYJNBUFMZwCFZPOEUIFUPQ
of the door frame.
2. 1SFESJMMwEFFQQJMPUIPMFTJOEPPSGSBNFBU
FBDIIJOHFBOEGBTUFOVTJOHwVOQBJOUFE
screws from the installation kit.
G
a
TOP
PARTE SUPERIOR
HAUT
GD
BOTTOM
PARTE INFERIOR
BAS
b
i
VIEW
i
VIEW
i
VIEW
D
Tools needed:
1”
x 8
x 4
1/2”
Painted
I
1/8”
Do not drill completely through door. This will create an
unnecessary hole in the door and may cause water and
air inltration.
CAUTION
PROFILE
PERFIL
PROFIL