Installation Guide

9
3/16”
F F
ADJUST
SWEEP &
INSTALL LATCH
RAIL
(Right Hand)
9
F
1/8”
Tools needed:
b
a
G
c
INSTALL
CLOSER AND
HANDLE SET
(Right Hand)
10
For pet door closer installation only:
1. 0QFOUIFEPPSBOENFBTVSFwVQGSPNUIF
top of the window opening on the interior
side of the door. Mark a line on the door
extending it to the hinge side door jamb.
This is where you will install your closer,
instead of at the bottom of the door.
2. Refer to the instructions in the installation
kit (I) to install the closer, keeping in mind
that your closer will be located at the TOP of
the door and not at the bottom.
For all other doors:
1. Refer to the instructions in the installation
kit (I) to install the closer.
1. Refer to the instructions included in the
installation kit (I) to drill the handle holes
and to install the door handles.
Installation
Kit
Installation
Kit
I
I
Tools needed:
1. Place the latch rail (F) in the opening with
the top end pushed up against the rain cap.
2. .BJOUBJOBDPOTJTUFOUwHBQCFUXFFO
latch rail (adjust latch rail as needed) and
side edge of door.
3. %SJMMBwQJMPUIPMFUISPVHIUPQNPVOUJOH
hole and into mounting surface.
If necessary, adjust the sweep.
1. From the interior, loosen the sweep screws
with a phillips screw driver. Adjust the
sweep (G) up or down until the sweep n
lightly comes into contact with the door sill.
2. Retighten the sweep screws.
a
2”
Pet Door Installation
X
VIEW
X
VIEW
X
VIEW
BOTTOM
PARTE INFERIOR
BAS
1”
x 6
I
1. 'BTUFOUPQPGUIFMBUDISBJMXJUIBwQBJOUFE
screw.
2. Re-check to make sure you have
NBJOUBJOFEUIFwHBQBOEESJMMwQJMPU
holes through the remaining mounting
holes.
3. 6TJOHUIFwQBJOUFETDSFXTGSPNUIF
installation kit, fasten the latch rail to the
mounting surface.
b