Installation Guide

3
Pre-installation information
RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
STORM DOOR TO DOOR OPENING SIZE CHART
If your door opening dimensions do not fall within these ranges, other
adjustments and reworks will be needed to provide a good fit.
NOMINAL FITS DOOR OPENING SIZES:
DOOR SIZE WIDTH HEIGHT
36"x80" door 35 3/4" to 36 3/8"
34"x80" door 33 3/4" to 34 3/8"
33"x80" door 32 3/4" to 33 3/8" 80" to 80 7/8"
32"x80" door 31 3/4" to 32 3/8"
30"x80" door 29 3/4" to 30 3/8"
RECOMMENDED TOOLS
• Safety Glasses
• Drill
• 3/32”, 1/8", 5/32" and 5/16”
drill bits
• Center punch
• Hacksaw
• Hammer
• Level
• Phillips head screwdriver
• Square
• Scissors or utility blade
• Tape measure
• Pencil
• Tape
Z-bar Extender Kits
are available for
these door opening
widths from your EMCO
storm & screen door dealer.
• To provide for the all-weather performance of your door, please read and follow the instructions carefully.
• If you are installing a double-door kit or sidelight storm window with your door, read those instructions first.
• Please handle your door with care to avoid damage and/or scratches.
• If your door has protective tape, do not remove it until instructed to do so.
• Be sure decorative side of molded frame faces outward.
• Please double-check that you have all of your parts before you discard your carton. All fasteners required for each step
are illustrated on page 2 for your convenience.
IIMMPPOORRTTAANNTT BBEEFFOORREE YYOOUU BBEEGGIINN
The insect screen is intended for reasonable insect control and not the retention of objects or persons within the interior. The insect screen material will
not stop a person from falling through the door.
WWAARRNNIINNGG
CAUTION
!
Weight of window and door unit(s) and accessories will vary. Use a reasonable number of people with sufficient strength to lift, carry, and install window
and door unit(s) and accessories. Always use appropriate lifting techniques. Failure to do so may result in injury.
WWAARRNNIINNGG
CAUTION
!
MEASURE THE ENTRYWAY
Measure the height and width of the door even with the brickmold as shown in the illustration.
Use the smallest width measurement to determine the opening width. Compare your door
opening height and width with the size chart to choose the appropriate size of your new
storm door. If the opening does not fall within any of these limits, it will be necessary to
rework the door jamb. You may wish to consult a professional carpenter to do so.
A
B
B
TOP VIEW
JAMB
EXTERIOR
BRICKMOLD
ENTRY DOOR
Opening Width
(see chart below)
B
B
Height measurement:
H=_____________
Smallest Width mea-
surement:
W=_____________
Measure A: The depth of the doorway
must be a minimum of 2-1/2". This is
required for handle clearance.
Measure B: The mounting area for
your storm door must be a minimum of
1"x1". This space is required for
secure installation.
36 3/8" to 37 3/8"
34 3/8" to 35 3/8"
33 3/8" to 34 3/8"
32 3/8" to 33 3/8"
30 3/8" to 31 3/8"