Installation Guide

9
12. ATTACH INSECT SCREEN TO WINDOW:
A. Raise the window with latches to approximately eye level.
B. Lower the hidden insect screen by pulling down on the orange
insect screen helper tab. Once the screen is exposed, grab and
hold the insect screen in one hand while you remove the helper
tab by twisting it and pushing it outwards. Next, pull the screen
down over the top of the Window Latch Rail. A slight pull
towards you will allow the Screen Pull Lip to maneuver around
the Window Latch Rail.
C. A slight push outwards will align the insect Screen Pull Lip
and Window Latch Rail. Raise the insect screen slightly. The
insect screen will be fully engaged when the Window Latch
Rail is interlocked with the Screen Pull Lip. See image to
right for proper positioning.
The retractable insect screen is stored inside the door
with a highly tightened spring. If released, insect
screen may release suddenly causing injury or product
damage. Maintain a firm grasp when attaching the
insect screen to the window.
WWAARRNNIINNGG
CAUTION
!
STEP 12B
FULLY ENGAGED
ORANGE
INSECT
SCREEN
HELPER TAB
WINDOW
LATCH
RAIL
INTERIOR VIEW
INTERIOR VIEW
11. ADJUSTING THE CLOSER:
A. Locate adjustment screw on the end of closer that attaches to the door frame.
B. Open door, then let it close to note current closing speed.
C. Use Phillips-head screwdriver to adjust closer to desired speed.
1. For faster closing speed, turn adjustment screw to the left (counterclockwise).
2. For slower closing speed, turn adjustment screw to the right (clockwise).
3. Test door (open it, then let it close) after each adjustment of the screw, and then
adjust screw further (if needed) until desired speed is achieved.
CLOSER
CYLINDER
ADJUSTMENT
SCREW
SCREWDRIVER
DOOR
LONG PIN
ADJUSTMENT
SCREW
END OF CLOSER
SLOWER
FASTER
INTERIOR VIEW
STEP 12C
1/8"
INSECT
SCREEN
PULL LIP
WINDOW
LATCH
RAIL
PUSH
SIDE VIEW
INSECT
SCREEN
PULL LIP
WINDOW
LATCH
RAIL
SIDE VIEW