User manual

DPSI BIC Operating Manual Version 2.0
Page 16 of 32
CAUTION:
The DPSI BIC is not reverse polarity protected by design! Please
observe that the batteries are always connected correctly, i.e. the
red wire always to the positive pole and the black wire always to
the negative pole. Please double check!
Hint:
The delivered cable for connecting the receiver holds two cables with a JR-
connector each. One plug connects to the battery slot of the receiver (power
supply). Put the second plug into any unused servo slot. Now the receiver is
supplied twice and voltage drop is lowered on load.
8. Charging the Batteries
The DPSI BIC switches battery positive, i.e. both batteries are, if
connected to the DPSI BIC, connected through negative (ground). If
charging of the batteries should be possible while they are connected
to the DPSI BIC, a second cable must be soldered to each battery or
the batteries must be connected by a V-cable (there is a charging
socket already integrated into LongGo batteries).