Owner`s manual

4. Pull 4 copper current carrying conductors (one each: black, red, white, green). Use either No. 6 AWG
60
o
C, No. 8 AWG 75
o
C, or No. 8 AWG 90
o
C wire, if spa is 100 feet or less away from its power supply.
Note: the ground must be equal to or larger than the largest power conductor.
5. Reposition the spa at its final location and route the flexible conduit.
6. Using a 1" conduit connector at the end of the flexible conduit, route wires through an entrance hole cut
by your electrician in the control enclosure, and attach the conduit connector to the control enclosure.
240V Systems
[Continued]
Figure 1 Figure 2
Installation Instructions
11
Under Spa
Cabinet