Owner`s manual

Spa Side Control
SC-1 & SC-2
for EMERALD BASE
Start-up for SC-1 & SC-2 Controls
Your spa control has been specifically designed so that by simply connecting the spa to its properly grounded
source, the spa will automatically heat to the set temperature. (note: your spa equipped with the SC-1 is shipped in the
240V configuration. See the SC-1 schematics on page 55 if you plan to convert the SC-1 power system to a 120V configura-
tion.)
Starting the pump:
Press Pump key to turn pump on. Press a second time to change pump speed. A third time turns pump off. A
built-in timer automatically turns pump off after 15 minutes, unless it has been manually deactivated first.
The "Pump" indicator lights up when pump is on.
Turning the light on:
Press Light key to turn light on. Press a second time to turn light off. A built-in timer
automatically turns light off after 2 hours, unless it has been manually deactivated first.
The "Light" indicator lights up when light is on.
Setting water temperature:
Use Up or Down arrow key to regulate water temperature. Press and hold key to increase (or decrease)
current temperature setting. The temperature setting will be displayed for 5 seconds to confirm your
new selection.
The "Set Point" indicator displays the desired temperature, NOT the current water temperature!
Water temperature can be adjusted by 1° increments from 59 to 104°F (15 to 40°C).
18
Emerald Spa Owner's Manual