Owner`s manual

Spa Side Control
SC-1 & SC-2
for EMERALD BASE
[continued]
Troubleshooting:
20
Emerald Spa Owner's Manual
Water temperature is flashing.
Water temperature in the spa
has reached 112°F (44°C).
Do not enter the water!
Remove spa cover and allow
the water to cool down.
The system will reset itself
when water reaches 109°F
(43°C).
Call your dealer or service
supplier if problem persists.
The pump has started up for
1 minute on several occasions
and "Filter" indicator is flashing.
Not a bug but a feature!
Our Smart Winter Mode
protects your spa from the
cold by turning the pump on
for 1 minute several times a
day to prevent water from
freezing in pipes.
The display is flashing.
A power failure must have
occurred. Press any key to
stop the flashing and repro-
gram the filter cycle.
3 flashing dots are displayed.
A problem has been detected.
Do not enter the water! Check
and open water valves. Clean
filter if necessary. Check water
level. Add water if needed.
Shut power off and power
your spa up again to reset
the system.
Call your dealer or service
supplier if problem persists.