Owner`s manual

26
Emerald Spa Owner's Manual
Spa Side Control
MC-2 & MC-4
for ELITE, SE deluxe
or Cygnus Spas
Programming
7 Step
Programming
Sequence
Lock
icon
Temperature
unit
Programming Mode
icon
Filter Cycle
icon
Heater
icon
Economy Mode
icon
Up & Down
arrows
Setting the time - Step 1:
1- Enter Programming mode by holding Prog. key pressed down for 2 seconds.
2- The display will show the current setting.
3- Use Up and Down arrows to change setting.
Setting filter cycle start time & duration - Steps 2 & 3:
The system automatically performs two filter cycles per day, at 12-hour intervals. During the filter cycle,
Pump 2 and blower will run in high speed for one minute. Pump 1 will then run for a programmed number
of hours. The "Filter Cycle" icon lights up when a filter cycle is on.
To program a filter cycle, you must enter: 1) the time you want the cycle to start and 2) the duration of the
cycle. If no filtering is required, the duration should be set to "0". For continuous filtering, the filter cycle
duration should be set to "12:00".
Setting filter cycle start time:
1- Press Prog. key a second time.
2- The display will show FSxx, with "xx" representing the starting hour.
3- Use Up and Down arrows to change setting.
Setting filter cycle duration:
1- Press Prog. key a third time.
2- The display will show Fdxx, with "xx" representing the duration in hours.
3- Use Up and Down arrows to change setting.
11:43 pm
10:25 am
FS12
FS01
Fd12
Fd00