Owner`s manual

Spa Side Control
MC-6
VANTAGE SPA
[continued]
Note:
The filter cycle is suspended if the
water temperature raises more than
2˚F (1˚C) above Set Point.
The "Filter" icon will blink
(on 0.5 second, off 0.5 second, on 0.5
second, off 1.5 seconds).
31
Features and Controls
Turning the light on:
Pressing Light key turns light on at high intensity. Pressing a second and third time changes its intensity. Press a
forth time to turn light off. A built-in timer turns light off after 2 hours, unless it has been manually deactivated
first.
The "Light" icon is displayed when light is on at high intensity. It flashes when light is on at medium
and low intensity.
Setting water temperature:
Use Up or Down arrow key to regulate water temperature. The temperature setting will be displayed for 5
seconds to confirm your new selection.
The "Set Point" symbol indicates the desired temperature, NOT the current water temperature!
Water temperature can be adjusted by 1˚ increments from 59 to 104˚F (15 to 40˚C).
Automatic water heater start:
When water temperature is 1˚F (0.5˚C) lower than the Set Point, the heater will automatically turn on until water
temperature reaches Set Point plus 1˚F (0.5˚C).
The "Heater" icon lights up when the heater is on. It flashes when there is a request for more heat
but the heater has not yet started.
Inverted display:
Press and hold Blower for 5 seconds to invert the display. Note that the ˚F or ˚C icon is not displayed in reverse
mode. Follow the same procedure to return to default mode. If a power-up occurs, the display always returns to
default mode.
Temperature display unit:
Press and hold Light key for 5 seconds to display water temperature in either Fahrenheit (˚F) or Celsius (˚C).