Owner`s manual

Emerald Spa Owner's Manual

Caution:

Low water level can damage the water circulating system and

void your warranty. Read and understand all safety,

location, and installation instructions before proceeding.

Add water until level is at appropriate level for your model's

skimmer (see page 40) or damage to system may result.

Proper Water Level

Bleeding Air

Caution: Air must be bled from the system. Air in the system can damage the spa and void the warranty.

Dual Filter

1. While the spa is off use the filter key to unscrew and remove the filter caps. This allows for the

large pocket of air naturally formed when the spa was filled with water to escape from the filter cavity.

2. Once the water level inside the filter housing has reached the same level as the water inside the spa you

can then replace the filter caps.

3. Tighten the filter cap snuggly using the filter key. Be sure not to overtighten. When the spa is running,

you should not see or hear any water leaking from the spot where the filter top meets the housing. If

you see or hear water escaping turn the spa off and retighten the filter lid.

Single Filter

1. While the spa is operating in low speed, turn the bleeder screw located on the top of the filter lid

counter-clockwise one half turn. This will allow air to escape.

2. When water appears turn the screw clockwise to shut the valve until the water no longer is seen

coming out. Be sure not to over-tighten as to not crack the valve.

Dual Filter Single Filter

Bleeder Valve