Owner`s manual

ELECTRICAL REQUIREMENTS

AND INSTALLATION

The following information is provided for hooking up electrical supply to

your new spa. A qualied, licensed electrician must perform this work.

Failure to follow these instructions will terminate all warranty coverage

and can cause serious injury or death.

Your Artesian spa is preset at the factory to run on 240V with a 48

amps input. This feature gives you the most performance out of your

spa. This will require a 240V, 60-amp GFCI. If a 60-amp service is not

available, your spa can be made to run with 32 or 40 amps input

rating. Press the SELECT key on the spa control pack to change the

input rating.

ELECTRICAL WIRING

WARNING: Your spa must be wired by a certied electrician and

according to these instructions. Failure to do so will terminate all

warranties and all listings from the independant listing facility.

1) The Gold Class Spa requires a 240 VAC dedicated

system. The spa must be hardwired to the power supply, with no

plug-in connections, extension cords, or sharing of service.

2) The spa requires that you run 6 or 8 AWG copper wire, depending

on the GFCI size. Do Not Use Aluminum Wire.

3) The power supply must have a suitable Ground Fault Circuit

Interrupter (GFCI), according to Section 422-20 of the National

Electrical Code, ANSI/NFPA 70-7987. This could be used as the

shut-off switch, which must be installed in plain view of the spa. This

electrical service must be readily accessible to the spa occupants,

but must not be within 5 feet of the spa.

4) Use only non-metallic conduit and ttings when installing power to

the spa.

5) After your spa has been positioned, route lines through the knockout

on the left or right front corner of the spa.

6) Connect the power to the spa.