Owner`s manual

SPA START-UP

FILLING THE SPA WITH WATER

NOTE: DO NOT ll your spa with hot water straight out of your

water heater or tap. This water may be as hot as 180 degrees F

and will cause damage to the surface and plumbing of the spa.

This will void your warranty. Level the spa before lling.

1) Prepare to ll the tub by removing all debris.

2) Remove the lters from your spa (see Removing, Installing and

Cleaning Filters, page 34).

3) Place your garden hose in the lter line as shown in the picture

below.

4) Fill the tub from the lter line line until water level is above

the foot-well.

Note: This will purge all the air out of the circulation pump.

An air lock can cause damage to the circulation pump

and is not covered under warranty.

5) Once the water level is lled over the foot-well, you can pull the

hose out of the circulation line and continue lling the spa from the

lter well.

6) Fill the spa to the bottom of the pillows. Note: DO NOT OVER-FILL

YOUR TUB!