Owner`s manual

Spa Side Control
Panel SS-1D
Start-up
When your spa is first powered up, it will automatically heat and maintain 100
o
F until you change the set
temperature. Immediately after start-up, the spa will begin a 3 hour filter cycle to clean the water. To select
a different duration, see "Preset Filter Cycles" below.
Temperature Adjustment (60
o
F - 104
o
F)
Press the pad to display the temperature previously set. Pressing the pad a second time will cause the
set temperature to increase or decrease depending on what direction was last chosen. Each successive press
will change the set temperature in the same direction.
If the opposite direction is desired, release the pad and let the display revert to the actual water tempera-
ture again. Press the pad to display the set temperature, and again to make the temperature change in the
desired direction.
Light and Jets Keypad
Touch the pad once to turn on the spa light. Touch the pad again, and the light, low-speed pump, and
ozone generator (if installed) will operate. Press the pad a third time, and the light and the high-speed
pump will run. Press the pad again, and only the high-speed pump will run. Press the pad again to turn
the high-speed pump off. The light will automatically turn off after 1 hour of use. The low-speed pump
and ozone generator (if installed) turn off after 2 hours, and the high-speed pump after 15 minutes. The
low-speed pump starts automatically when the heater is turned on. If automatically activated, the low-
speed pump cannot be turned off with the function pad; however, the high-speed pump may be started.
Preset Filter Cycles
Your spa will automatically filter itself for 3 hours, twice each day. The first filter cycle will start one
minute after the spa is powered up. The second filter cycle will begin twelve hours later. The low-speed
pump and ozone generator (if installed) will run during filter cycles.
20
Emerald Whirlpool Spa Owner's Manual