Owner`s manual

24
Emerald Whirlpool Spa Owner's Manual
Spa Side Control
Panel DS-2
Start-up
Your spa control has been specifically designed so that by simply connecting the spa to its properly
grounded source, the spa will function properly and safely at 100
o
F. When your spa is first activated, the
LCD will display the current spa temperature and COOL in the display window if the water is 20
o
F cooler
than the set temperature. During each filter cycle, the spa will heat to the set temperature.
User's Keypads
Temperature Controls (60
o
F - 104
o
F)
The current temperature is constantly displayed on the LCD. Press either the up
(warm) or down (cool) arrows once to display the set temperature. (The set
temperature is designated by a triangle in the upper left corner.) Each time either
pad is pressed again, the set temperature will increase or decrease depending upon
which pad is pressed. After three seconds, the LCD will automatically display the current spa temperature.
Jets Keypad
Touch this pad once to activate the low-speed pump. Touch again to activate the
high-speed. Press the pad a third time and the second pump will also activate. Press the
pad again to deactivate the pump(s). The low-speed pump starts automatically when the
heater is turned on, when a filter cycle is activated, or when a freezing condition is detected. If automati-
cally activated, the low-speed pump cannot be turned off with the "jets" pad; however, the high-speed
pump may be started. When the low-speed pump is started with this pad, it will automatically stop after 2
hours and 20 minutes of operation. The high-speed pump will stop after 15 minutes.
Blower Keypad
Touch the blower keypad to activate the first speed of the blower (high). Press the pad
again to activate the second speed of the blower (low) and once again to turn the blower off.
The blower will automatically turn off after 15 minutes.
Light Keypad
Press this pad to operate the light cycle. The light will automatically turn off after 1 hour of
operation. If your spa is equipped with optional fiber optic lighting, then 4 colors will cycle
once you press the light keypad. To stop on a desireable color press the light keypad a
second time. To turn the fiber optic lighting off press a third time.