Owner`s manual

Spa Side Control

Panel DS-4

(continued)

Optional Filter Cycles

While you are not required to set filter cycles, if you want to change them, press the time pad, and the star

(*) pad twice all within 3 seconds. "SET START FILTER 1" (AM cycle) will appear on the display.

Press the "Warm" or "Cool" keypad to reset the filter start time.

When "SET HEAT" is on the display, press the "Warm" pad to enable or press the "Cool" to disable the

heater during filtering.

Press the star (*) pad to see "STOP FILTER 1" and adjust the time with the "Warm" or "Cool" pad as done

above.

Press the star (*) pad to see "START FILTER 2" (PM cycle) and proceed as above.

Pressing the mode (#) pad will enter the new filter cycle times into the system and display the current water

temperature.

Cleanup Cycle

Your spa has an automatic cleanup cycle which circulates and maintains the cleanliness of the water.

Twenty minutes after the "Jets" pad has last been pressed the cleanup cycle will begin. (Due to preset time-

outs, the spa assumes that you are finished using the spa 20 minutes after the "Jets" pad is pressed.) During

the clean up cycle, the circulating pump will turn on for a 2 hour period and the panel will display "FIL-

TER".

If the "JETS" pad is pressed during the cleanup cycle, the cleanup cycle will shut off. Twenty minutes after

the "JETS" pad is pressed, the cleanup cycle will begin again.

Disabling Pumps

In times when you are entertaining or relaxing in the area of your spa, you can turn off the pump to avoid

hearing any spa operational noise due to filtering or ozonating. To do this press the "Time" then "Down"

button and ILOC will appear on the display, and all spa functions will be disabled except for freeze control.

To resume spa operation, press any panel button.

Invert Temperature Display

To view the temperature display from the inside of the spa or from the outside, press the "TIME" pad then

the ▲ or ▼ for either direction.

Features and Controls