Owner`s manual

Cleaning the

Spa Shell

Note:

Do not use scouring

cleansers or solvents;

damage to the acrylic

finish will result.

Note:

Do not use strong

solvents such as

gasoline, acetone, or

denatured alcohol;

damage to the acrylic

finish will result.

Cleaning the Filter

Use a nonabrasive household cleaner to clean all spa shell surfaces and fixtures. Do not use scouring

cleansers or solvents; damage to the acrylic finish will result.

Your Emerald Whirlpool Spa is manufactured using LUCITE XL 1000 continuous-cast cross-linked acrylic

sheet. This material provides a strong chemical-resistant high gloss surface that is hard, nonporous, and

impermeable to water.

Given proper care, the polished, lustrous surface of LUCITE XL 1000 sheet will retain its appearance for

many years. To clean your spa be sure to use a soft absorbent cloth with any of the commercially available

nonabrasive foam or liquid agents in general cleaning concentrations. Always rinse thoroughly with clean

water and a soft chamois or moist cellulose sponge.

Cleaning agents containing strong abrasives such as scouring powders or strong solvents such as gasoline,

acetone, or denatured alcohol should not be used to clean the acrylic surface of your spa.

Fine scratches may be minimized by the use of a mild automobile cleaner-polish. The cleaner-polish has a

fine abrasive action, and its wax content tends to fill small scratches to make them less visible.

1. Turn off power at GFCI, circuit breaker before performing any service. For DS-2 and DS-4 models

you may want to use the stand-by mode by pressing the ▲ or ▼ pad, then the "light" pad for the

DS-2 and if you have a DS-4 you simply press "time" then the▼ pad.

2. Using a filter key, open filters and remove elements.

3. Clean the filter elements as required:

- Spray with a garden hose to remove trapped dirt.

- Soak in a solution of water and automatic dishwasher detergent to remove body oils

and other contaminants or see your dealer for recommended cleaning supplies.

- Inspect the elements for damage and replace as required.

- Rinse thoroughly.

4. Place clean filter elements in housing and install filter tops.

5. Turn the power on at GFCI, circuit breaker. For Stand-by mode, touch any keypad to resume spa

operation for DS-2 and DS-4.

Maintaining Your Spa