Owner`s manual

4. Determine the length of flexible conduit required to run between
the LB and control enclosure.
5. Pull 4 copper current carrying conductors (one each: black, red,
white, green). Use either No. 6 AWG 60
o
C, No. 8 AWG 75
o
C, or
No. 8 AWG 90
o
C wire, if spa is 100 feet or less away from its power
supply.
6. Reposition the spa at its final location and route the flexible
conduit.
7. Using a 1" conduit connector at the end of the flexible conduit,
route wires through an entrance hole cut by your electrician in
the control enclosure, and attach the conduit connector to the
control enclosure.
240V Systems
[Continued]
11
Installation Instructions
Figure 1
Figure 2