Owner`s manual

Spa Side Control

Lite Leader

Start-up

Your Lite Leader control has been specifically designed so that by simply

connecting the spa to its properly grounded source, the control will auto-

matically heat the water to the set temperature. Your spa equipped with

the Lite Leader is shipped in the 240V configuration. See the Lite Leader

schematics on page 53 if you plan to convert the Lite Leader power system

to a 120V configuration.

Temperature Adjustment (80

F - 104

Temperature adjustment is controlled by pushing the pad. The display

shows the actual water temperature unless the pad is pressed. When the

pad is pressed, the display will show the set temperature. Pressing the pad

a second time will cause the set temperature to increase or decrease de-

pending on what direction was last chosen. Each successive press will

change the set temperature in the same direction.

If the opposite direction is desired, release the pad and let the display

revert to the actual water temperature again. Press the pad to display the

set temperature, and again to make the temperature change in the desired

direction.

Light and Jets Keypad

Press the pad once to turn on the light. Press the pad again and the

low-speed pump, light and ozone generator (if installed) will operate.

Press the pad a third time and the high-speed pump and light will run.

Press the pad again and only the high-speed pump will be on. Press the

pad a final time to turn off all functions. The light will automatically turn

off after 4 hours of operation. The low-speed pump and ozone generator (if

installed) turn off after 2 hours, and the high-speed pump turns off after 15

minutes of operation. The low-speed pump starts automatically when the

heater is turned on. If automatically activated, the low-speed pump cannot

be turned off with the function pad; however, the high-speed pump may be

started.

Emerald Whirlpool Spa Owner's Manual