Owner`s manual

Spa Side Control
Panel SS-1D
Start-up
When your spa is first powered up, it will automatically heat and maintain
100
o
F until you change the set temperature. Immediately after start-up, the
spa will begin a 3 hour filter cycle to clean the water. To select a different
duration, see "Preset Filter Cycles" below.
Temperature Adjustment (60
o
F - 104
o
F)
Press the pad to display the temperature previously set. Pressing the
pad a second time will cause the set temperature to increase or decrease
depending on what direction was last chosen. Each successive press will
change the set temperature in the same direction.
If the opposite direction is desired, release the pad and let the display
revert to the actual water temperature again. Press the pad to display the
set temperature, and again to make the temperature change in the desired
direction.
Light and Jets Keypad
Touch the pad once to turn on the spa light. Touch the pad again, and
the light, low-speed pump, and ozone generator (if installed) will operate.
Press the pad a third time, and the light and the high-speed pump will run.
Press the pad again, and only the high-speed pump will run. Press the pad
again to turn the high-speed pump off. The light will automatically turn off
after 1 hour of use. The low-speed pump and ozone generator (if installed)
turn off after 2 hours, and the high-speed pump after 15 minutes. The low-
speed pump starts automatically when the heater is turned on. If automati-
cally activated, the low-speed pump cannot be turned off with the function
pad; however, the high-speed pump may be started.
Preset Filter Cycles
Your spa will automatically filter itself for 3 hours, twice each day .
The first filter cycle will start one minute after the spa is powered up.
The second filter cycle will begin twelve hours later. The low-speed pump
and ozone generator (if installed) will run during filter cycles.
20
Emerald Whirlpool Spa Owner's Manual