Owner`s manual

22
Emerald Whirlpool Spa Owner's Manual
Spa Side Control
Panel SS-3D
Start-Up
Your spa control has been specifically designed so that by simply connect-
ing the spa to its properly grounded source, the spa will automatically heat
to the set temperature.
Temperature Adjustment (60
o
F - 104
o
F)
Spa temperature is controlled by pressing the "Set" pad. The display shows
the actual water temperature unless the pad is pressed. When the pad is
pressed, the display will show the set temperature. Pressing the pad a
second time will cause the set temperature to increase or decrease depend-
ing on what direction was last chosen. Each successive press will change
the set temperature in the same direction.
If the opposite direction is desired, release the pad and let the display
revert to the actual water temperature again. Press the pad to display the
set temperature, and again to make the temperature change in the desired
direction.
Jets Keypad
Touch the "Jets" pad once to activate the low speed pump. Touch the
pad again to activate the high-speed pump. Press the pad a third time to
deactivate the pump. The low-speed pump starts automatically when the
heater is turned on, when a filter cycle is activated, or when a freezing
condition is detected. If automatically activated, the low-speed pump
cannot be disabled from the front panel; however, the high-speed pump
may be started. Whenever the low-speed pump is energized with this pad,
it will automatically turn off after 2 hours. The high-speed pump turns off
after 15 minutes.
Air Keypad
Press the "Blower" pad to turn the air jets on and off. The air jets will
automatically turn off after 15 minutes of use.
Light Keypad
Press the "Light" pad to turn the spa light on and off. The spa light will
automatically turn off after 1 hour.