Owner`s manual

Spa Side Control

Panel SS-3D

(Continued)

Preset Filter Cycles

Your spa will automatically filter itself twice each day. The first filter

cycle will begin one minute after the spa is energized. The second filter

cycle will begin twelve hours later. To clean out the blower lines, the air

jets will run for 30 seconds at the start of the first filter cycle. During

filtration, the low-speed pump will activate. The ozone generator (if

installed) will run 24 hours per day, but is assisting with water purification

only when the pump is running. Filter duration is programmable via the

topside panel.

Setting the Filter Cycles

Press the "Set" pad, then the "Jets" pad, and "F3" will be displayed on the

panel. "F3" is the default filter time and indicates a 3 hour cycle. Press the

"Set" pad again to cycle through the rest of the filter time options; "F6" = 6

hours, "F9" = 9 hours, and "FC" = 12 hours. After you have selected your

duration, press the "Jets" pad again to exit the programming mode.

Safety Features

Overheat Protection (Spa is deactivated)

If your spa should overheat, the display will flash {OH}. In such a

condition, DO NOT ENTER THE WATER. Turn off all power to the spa

and contact your dealer or service organization. Overheating may also

occur if the filter duration is set too long at the time of installation. To reset

the spa, press any panel button.

Flow Switch Detection

If a pressure switch malfunctions, the display will show {FL}. Contact your

dealer or service organization.

Open Sensor (Spa is deactivated)

If the high-limit sensor or water temperature sensor malfunctions, the

display will show {Sn}. Contact your dealer or service organization.

Features and Controls