Owner`s manual

24
Emerald Whirlpool Spa Owner's Manual
Spa Side Control
Panel DS-2
Start-up
Your spa control has been specifically designed so that by simply
connecting the spa to its properly grounded source, the spa will function
properly and safely at 100
o
F. When your spa is first activated, the LCD
will display the current spa temperature and COOL in the display window
if the water is 20
o
F cooler than the set temperature. During each filter
cycle, the spa will heat to the set temperature.
User's Keypads
Temperature Controls (60
o
F - 104
o
F)
The current temperature is constantly displayed
on the LCD. Press either the up (warm) or down
(cool) arrows once to display the set temperature.
(The set temperature is designated by a triangle in
the upper left corner.) Each time either pad is pressed again, the set
temperature will increase or decrease depending upon which pad is
pressed. After three seconds, the LCD will automatically display the
current spa temperature.
Jets Keypad
Touch this pad once to activate the low-speed pump. Touch
again to activate the high-speed. Press the pad a third time
and the second pump will also activate. Press the pad again
to deactivate the pump(s). The low-speed pump starts automatically when
the heater is turned on, when a filter cycle is activated, or when a freezing
condition is detected. If automatically activated, the low-speed pump
cannot be turned off with the "jets" pad; however, the high-speed pump
may be started. When the low-speed pump is started with this pad, it will
automatically stop after 2 hours and 20 minutes of operation. The high-
speed pump will stop after 15 minutes.
Blower Keypad
Touch the blower keypad to activate the first speed of the
blower (high). Press the pad again to activate the second
speed of the blower (low) and once again to turn the blower
off. The blower will automatically turn off after 15 minutes.
Light Keypad
Press this pad to operate the light cycle. The light will auto-
matically turn off after 1 hour of operation. If your spa is
equipped with optional fiber optic lighting, then 4 colors
will cycle once you press the light keypad. To stop on a desireable color
press the light keypad a second time. To turn the fiber optic lighting off
press a third time.