Owner`s manual

Emerald Whirlpool Spa Owner's Manual

Spa Side Control

Panel DS-4

(continued)

Light Keypad

Press this pad to operate the light cycle. The light will auto-

matically turn off after 1 hour of operation. If your spa is

equipped with optional fiber optic lighting, then 4 colors

will cycle once you press the light keypad. To stop on a desireable color

press the light keypad a second time. To turn the fiber optic lighting off

press a third time.

Time

Press this pad to view time of day and press again to view

temperature. Current spa temperature display will auto-

matically resume after 3 seconds.

2. Liquid Crystal Display

This display continually shows operating status of

the spa, as well as the various monitoring functions

and programing information.

3. User's Program Keypads

Program function

This pad initiates time setting, 7-day programming, 24-hour

pump operation and panel lock routines.

Mode function

Press this pad to switch spa operation to either the Economy

or Standard mode. When the Economy mode is selected,

the heater will maintain a temperature of 20

F below the

preset temperature. In the Standard mode, the preset spa temperature will

be maintained. This pad also resets the control in the event of an overheat

display message (see Center Display Messages).

Automatic Operations

Preset Filter Cycles

Your spa filter cycles are pre-programmed from the factory to automati-

cally filter for a 3-hour period every 12 hours. The first filter cycle is

automatically activated at 2:00 AM and runs till 5:00 AM. The second cycle

is between 2:00 PM and 5:00 PM. During these cycles the heater will

operate in the economy mode.