Owner`s manual

Spa Side Control

Panel DS-4

(continued)

Optional Filter Cycles

While you are not required to set filter cycles, if you want to change them,

press the time pad, and the star (*) pad twice all within 3 seconds. "SET

START FILTER 1" (AM cycle) will appear on the display.

Press the "Warm" or "Cool" keypad to reset the filter start time.

When "SET HEAT" is on the display, press the "Warm" pad to enable or

press the "Cool" to disable the heater during filtering.

Press the star (*) pad to see "STOP FILTER 1" and adjust the time with the

"Warm" or "Cool" pad as done above.

Press the star (*) pad to see "START FILTER 2" (PM cycle) and proceed as

above.

Pressing the mode (#) pad will enter the new filter cycle times into the

system and display the current water temperature.

Cleanup Cycle

Your spa has an automatic cleanup cycle which circulates and maintains

the cleanliness of the water.

Twenty minutes after the "Jets" pad has last been pressed the cleanup cycle

will begin. (Due to preset time-outs, the spa assumes that you are finished

using the spa 20 minutes after the "Jets" pad is pressed.) During the clean

up cycle, the circulating pump will turn on for a 2 hour period and the

panel will display "FILTER".

If the "JETS" pad is pressed during the cleanup cycle, the cleanup cycle will

shut off. Twenty minutes after the "JETS" pad is pressed, the cleanup cycle

will begin again.

Disabling Pumps

In times when you are entertaining or relaxing in the area of your spa, you

can turn off the pump to avoid hearing any spa operational noise due to

filtering or ozonating. To do this press the "Time" then "Down" button and

ILOC will appear on the display, and all spa functions will be disabled

except for freeze control. To resume spa operation, press any panel button.

Invert Temperature Display

To view the temperature display from the inside of the spa or from the

outside, press the "TIME" pad then the ▲ or ▼ for either direction.

Features and Controls