Owner`s manual

Emerald Whirlpool Spa Owner's Manual

Programming

Initial Start-up

Your Spa Control has been specifically designed so that by simply

connecting the spa to its properly grounded source and touching the Mode

[#] pad, the spa will function properly and safely at 100

F. In this mode,

all user pads will be completely functional. The spa will just about take

care of itself. However, to fully utilize the unique capabilities of the

control, it is important to set the time of day and the day of the week

properly.

Setting the Time

Once the spa has been properly connected, notice the "SET TIME" message

flashing on the screen.

PRESS THEN THEN

OR After either pad is pressed once, hours will

advance or decrease automatically in one-minute

increments. Press either pad again to stop the

display's time-setting cycle.

Spa Side Control

Panel DS-4

(continued)

Panel Lock

To help prevent unauthorized use of your spa, the Cygnus control has

incorporated a unique panel locking system. When the panel lock is en-

gaged, all automatic spa functions will operate normally.

To lock the panel

These pads must be pressed in the correct sequence and within 3 seconds to

activate the lock. When locked, the center display will show the spa tem-

perature along with the lock symbol. All the pads are now

deactivated except the program pad, which is used to initiate the unlock

sequence.

PRESS THE CENTER DISPLAY WILL READ

THEN