Owner`s manual

Starting and Using Your Spa

One pump Priming

[for spas equipped

with Lite Leader,

SS-1D, and SS-3D]

Note:

If water does not flow within

a minute or two, turn off

power to the spa and repeat

steps for bleeding the air.

Testing the GFCI

[for spas equipped

with Lite Leader (240V)

SS-1D, SS-3D, DS-2,

and DS-4]

Caution:

Never run the system without circulating water. Doing so can damage the

pump and void the warranty.

1. Press the "Jets" key pad. The pump will begin to operate in the

high-speed mode; this will facilitate pump priming.

2. When your jets begin to operate vigorously, the pump is

completely primed.

Your spa must be provided with a GFCI-circuit breaker located in the

power supply panel as installed by your electrician. Turn on the circuit

breaker and test the GFCI by pushing the test button. A red indicator

should appear and your spa should stop operating. Push the reset button

and the red indicator should disappear. The spa should begin to operate

normally.

WARNING:

If the GFCI fails to operate in this manner, there is a risk of electric shock!

Shut off the main power source. Identify and correct problem before using

the spa.