Owner`s manual

Emerald Whirlpool Spa Owner's Manual

Two-Pump Priming

[for spas equipped

with DS-2 and DS-4]

Note:

If water does not flow within a

minute or two, turn off all power

to the spa and repeat steps for

bleeding air.

Caution:

Never run the system without circulating water! Doing so can damage

pumps and void the warranty.

Each pump must be primed separately. To accomplish this, follow these

steps.

1. Press the "Jets" key pad twice. The circulating/jets pump will

operate in the low speed mode on the first press and in the high

speed mode on the second press. The high speed mode will

facilitate pump priming.

2. When the jets begin to operate moderately, the circulating/jets

pump is completely primed.

3. Now press the "Jets" key pad a third time. The jets booster pump

will now operate.

4. When the jets begin to operate more vigorously, the jets booster

pump is completely primed. If you do not see any distinguishing

difference in jet flow when pressing the "Jets" button a third time

then the booster pump may require direct priming.

A. Remove the equipment panel and locate the booster pump

(see 2-pump system diagram on page 16).

B. With the booster pump running turn the pump drain plug

counterclockwise until a steady stream of water appears.

Once water appears quickly tighten the plug and you

should notice a more intence flow of water through the jets.

C. If no noticeable difference has occured repeat step B.

Water Line Connection goes to the jet