Owner`s manual

Emerald Whirlpool Spa Owner's Manual

Draining the Water

Note:

Chemically treated water may

damage plants. Place the garden

hose in a safe discharge area.

Note:

Some water will be left in the

bottom of the spa and in your

plumbing lines. This small

amount of water can be mixed with

fresh water without consequence.

If 100% draining is required, a small

submersible pump or a wet/dry shop

vac should be used. If winterizing

your spa please turn to page 47 for

complete instructions.

MAINTAINING YOUR SPA

Draining the Water

Cleaning the Spa Shell

Cleaning the Filter

Space Saver II Filtration System

Relamping the Underwater Light

Standby Mode

Winterizing Your Spa

The Spa Cabinet

Caution:

Do not allow the pump to run without water. Running the pump

without water will cause pump damage and void the warranty.

To drain your Emerald spa:

1. Turn off the power at GFCI or circuit breaker before draining your

spa.

2. Open the equipment access panel and attach a garden hose to the

drain valve.

3. Open the drain valve and allow water to drain from your spa. Be

sure all circulating valves are open.

To drain your Cygnus or SE spa without taking access panel

off:

1. Turn off the power at GFCI or circuit breaker before draining your

spa.

2. Remove black drain cap and pull out hose with fitting to

allow for gravity drain.

3. Attach a garden hose to the drain fitting and open the ball

valve. (note: this method does require longer drain time)