Owner`s manual

Cleaning the Spa Shell

Note:

Do not use scouring cleansers or

solvents; damage to the acrylic

finish will result.

Note:

Do not use strong solvents such

as gasoline, acetone, or denatured

alcohol; damage to the acrylic

finish will result.

Cleaning the Filter

Use a nonabrasive household cleaner to clean all spa shell surfaces and

fixtures. Do not use scouring cleansers or solvents; damage to the acrylic

finish will result.

Your Emerald Whirlpool Spa is manufactured using LUCITE XL 1000

continuous-cast cross-linked acrylic sheet. This material provides a strong

chemical-resistant high gloss surface that is hard, nonporous, and imperme-

able to water.

Given proper care, the polished, lustrous surface of LUCITE XL 1000 sheet

will retain its appearance for many years. To clean your spa be sure to use

a soft absorbent cloth with any of the commercially available nonabrasive

foam or liquid agents in general cleaning concentrations. Always rinse

thoroughly with clean water and a soft chamois or moist cellulose sponge.

Cleaning agents containing strong abrasives such as scouring powders or

strong solvents such as gasoline, acetone, or denatured alcohol should not

be used to clean the acrylic surface of your spa.

Fine scratches may be minimized by the use of a mild automobile cleaner-

polish. The cleaner-polish has a fine abrasive action, and its wax content

tends to fill small scratches to make them less visible.

1. Turn off power at GFCI, circuit breaker before performing any

service. For DS-2 and DS-4 models you may want to use the

stand-by mode by pressing the ▲ or ▼ pad, then the "light" pad

for the DS-2 and if you have a DS-4 you simply press "time" then

the ▼ pad.

2. Using a filter key, open filters and remove elements.

3. Clean the filter elements as required:

- Spray with a garden hose to remove trapped dirt.

- Soak in a solution of water and automatic dishwasher detergent

to remove body oils and other contaminants or see your dealer for

recommended cleaning supplies.

- Inspect the elements for damage and replace as required.

- Rinse thoroughly.

4. Place clean filter elements in housing and install filter tops.

5. Turn the power on at GFCI, circuit breaker. For Stand-by mode,

touch any keypad to resume spa operation for DS-2 and DS-4.

Maintaining Your Spa