User's Manual
Page 86
J-400 Series
18.8 Generic MP3 Player Operation
1. Connecting Your MP3 Player
A. Plug in any MP3 player’s
headphone output jack
with supplied cable into
the auxiliary port (11)
using the supplied audio
RCA cable. Close stereo
compartment during use
to prevent moisture from
entering the compartment.
2. Setting Up The MP3
Player for Use
A. Select preferred song/
album/playlist prior to
plugging in MP3 player
and start playback.
B. Press “Mode Button” on
stereo receiver until the LCD display reads “AUX”.
Note: All external MP3 player playback operations are performed solely
by the MP3 Player with the exception of volume control and “Mode
Button” selector, which can be controlled via wireless remote or on the
stereo receiver.
WARNING: Electrical Shock Hazard Exists!
are wet or while sitting partially or fully immersed.
18.9 J-1000™ Audio System Stereo Troubleshooting
1. Unit will not turn-on
Make sure spa power is turned on, then check both harness fuses on
side of unit making sure they are the proper ratings:
Yellow memory B+ line (1A fuse); Red ACC line (10A fuse).•
When faced with a malfunction during operation, push BND •
button (8) and Eject button (13) at the same time to reset
software.
With spa power off, use a paperclip to press the reset button •
located besides the USB Docking Station (10) to do a hardware
reset.
Note: It will be necessary to re-enter the radio preset memories and
other personal settings after performing a reset. After resetting player,
always ensure all functions are operation correctly.
1
2
17
3
98
75
46
10
11
13
15
12
16
14