User's Manual

Page 78

J-400 Series

18.2 Sound System Operation

1. Power On and Off

Press power button (1) once to turn on

stereo system. Press a second time to

turn off.

2. Adjusting Volume

Press VOL Up/Down button (3) to

increase or decrease volume. Current

volume setting is briey displayed

(0 to 45).

3. Mute

In Radio or AUX mode, press mute button (7) once to mute audio

output (“MUTE” ashes on display). To restore audio output, press

button (7) a second time, or press volume up or down button. In

CDP, USB, NAND mode, press button (7) to pause playback. Press

again to resume playback.

4. Program Selection

Press MODE button (4) to cycle through available program sources

as follows: Radio --> CDP --> USB --> NAND --> IPOD --> AUX

--> Radio. If a source is unavailable (e.g.: No CD, USB or IPOD

inserted), that source will not appear on the display (17).

5. Adjusting DSP Level

Press EQ button (5) repeatedly until display reads “FLAT”. Then

press VOL Up/Down button (3) to select sound mode: Flat, Rock,

Soft Rock, Jazz, Classic, Dance, Pop, Soft, Hard, Party, Vocal, Hip-

Hop, Dialog, Bass Boost 1 to 3, Loudness 1 to 16, or Flat.

6. Adjusting Bass Level

Press EQ button (5) repeatedly until display reads “BAS”. Press VOL

Up/Down button (3) to choose desired setting. A display of “BASS 0”

indicates center, -1 to -7 indicates bass cut, and +1 to +7 indicates

bass boost.

Note: Unit returns to volume mode if volume control is not operated for 3

seconds.