User's Manual

Page 13
J-400 Series
Figure D
1. Obtain a at head screwdriver.
2. Place it ush against the middle slot of the
terminal block (diagram 1), at almost a 90º angle.
Figure E
1. Lightly press inward and upward
on screwdriver blade, then pivot
upward to open underlying wire
clamp. Hold this position for step 2.
2. Insert power wire into slot A as
shown, then remove screwdriver to
release terminal block clamp and
secure wire in place. Gently pull on
wire after installation to verify it is
clamped tightly into terminal.
L1
L2
1
2
1
A
Screwdriver Slots
Power wire Slots
Side View
Side View