User's Manual

Page 65
J-400 Series
polishing bag lter and additional lter. The exclusive footwell “sweeper”
suction tting enhances ltration in the footwell area by creating a
“swirling” water motion to maximize particle agitation and pickup.
To ensure optimum performance, the 24-hour ProClear™
II skimming lter cartridge (A) must be cleaned every
three months and replaced once a year. The secondary
ProClear™ Plus polishing lter bag (B) should be emptied
weekly and replaced every 3 months. The ProClear™ II
lter cartridge (C) must be cleaned every three months
and replaced once a year. To accomplish this, refer to the
following lter cleaning procedure.
Note: Do not attempt to wash the polishing lter bag (B) or it will come
apart!
ALWAYS TURN POWER TO THE SPA OFF BEFORE CLEANING THE
FILTER CARTRIDGES! NEVER OPERATE SPA WITHOUT FILTER LID
(2) AND SKIMMER ASSEMBLY (4) INSTALLED.
A
B
2.1. 4. 5.
3.
1. Remove power to the hot tub before removing the skimmer (A) or
lter bag cover (B).
2. Remove the polishing bag lid (B) by rotating it counterclockwise
approximately 5 degrees until you feel it unlatch.
3. Remove the polishing bag by reaching into the lter bucket
and gently pulling upward on the blue lter ring (empty
lter bag weekly or install a new bag every three months.)
Located below the bag is a small Proclear lter. Remove
the lter by rotating it counterclockwise. For cleaning
procedures see step 6 below. Once the lter has been
cleaned or replaced, reinstall it into the skimmer below the
polishing bag. Replace bag, then install lter lid by rotating
it clockwise until you feel it latch in place. DO NOT FORCE
LID! FINGER TIGHT ONLY!
4. Remove the ProClear skimmer assembly (A) by gently lifting upward
from the lter bucket.
5. Remove the ProClear lter cartridge by rotating it counterclockwise
to unthread it, then remove the center cap and chemical dispenser
from the lter cartridge as shown (right).
A
B
C