User's Manual

Page 95
J-400 Series
7. iPod® Operation
You can scan through the track numbers, play or
pause and adjust the volume with the remote. When
you are in the iPod mode the screen will appear like
Figure H; then it will change to the track duration
screen for the track. Using the Navigational Quad
Keypad you can:
Increase the volume by pressing the Up button.•
Decrease the volume by pressing the Down button.•
Go to the previous track by pressing the Left button. Go to the •
next track by pressing the Right button.
Pause or play by pressing the Select button.•
Turn off the system by pressing and holding the Select button for •
longer than 3 seconds.
Go to the Main Menu by pressing the Return button.•
WARNING: Electrical Shock Hazard Exists! Never install or
remove iPod while hands are wet or while sitting partially
immersed or fully immersed in spa!
8. Error has occurred
If the remote senses an error that needs attention, it will
display the words “Spa” - “Err”, one word at a time, (see
Figure I). The words will cycle for 1 second each. Please
go to the main spa control panel for further instructions. If
this error is not detected by the user within 20 seconds, the
remote will go to sleep mode and the backlighting will begin
to ash on and off until the user a key is pressed.
iPod
Figure H
Figure I