- Emerson Electric Co. Wok User Manual

User Manual MON20/20 Software for Gas Chromatographs
3-9000-745 SEPTEMBER 2010
3-46
3.7.4 Mapping a system variable to an analog output
To select the system variable on which to base the signal level of the
analog output, do the following:
1. Select Analog Output... from the Hardware menu. The Analog
Output window displays.
Figure 3-37. The Analog Outputs window
2. Select a new variable by clicking on the appropriate drop-down list
under the Variable column. For a demonstration of how to use the
context-sensitive variable selector, see “Using the context-sensitive
variable selector” on page 1-42.