- Emerson Electric Co. Wok User Manual

6-1
Section 6: Controlling Analyses
The options in the Control pull-down menu allow
you to manage analysis runs as well as calibration,
validation and baseline runs. Control menu
commands also allow you to stop an analysis run
immediately or at the end of the run.
6.1 Halting an analysis
Before a new analysis run can be initiated, the current analysis must be
stopped. To stop the current analysis at the end of its cycle, do the
following:
1. There are three ways to halt an analysis run:
• Select Halt... from the Control menu.
•Press F3.
• Click on the Toolbar.
If you running in a mode that uses two detectors, MON 20/20 displays
a selector window.
Figure 6-1. The selector window
2. Choose the appropriate detector. A confirmation message displays.