Owner's Manual

Press to select the Fan Speed: Auto, Low, Med, or
High. On certain models the fan speed cannot be
adjusted under HEAT mode. On Dry mode the Fan
Speed will automatically be set to Low.
The new temperature will be maintained for 6 hours
then it will return to the previously programmed setting.
The LED (light) will illuminate after 250 hours of
operation as a reminder to clean the Air Filter for
optimal performance. To reset after cleaning the filter,
press the Check Filter button and the light will turn
off.
This feature can be activated from the remote control
ONLY. The remote control serves as a remote
thermostat allowing for precise temperature control.
To activate the Follow Me feature, point the remote
control towards the unit and press the Follow Me
button. The remote will display the actual temperature
from the remote’s location. A signal will be sent from
the remote control to the air conditioner in 3-minute
intervals. To end the Follow Me mode, press the Follow
Me button. If the unit does not receive the Follow Me
signal during a 7-minute interval, the unit will beep to
indicate it is no longer in Follow Me mode. To end the
Follow Me mode manually, press the Follow Me button.
to cycle through modes: Auto, Cool, Dry, Heat (select
models), and Fan. An indicator light will show the selected
mode. The unite will automatically start in Energy Saver
mode when Cool, Dry, Auto (only Auto-Cooling and
Auto-Fan) modes are selected.
In Auto mode, the unit will automatically select cooling,
heating (select models), or fan only mode depending on
the set temperature and the room’s current temperature.
In this mode, the fan speed cannot be adjusted manually.
The unit will automatically choose the speed based on the
set temperature and the room’s current temperature.
Use the Fan Only function to circulate the air in a room or
to exhaust stale air (select models) when cooling is not
necessary. Remember to open the vent in this mode, but
keep it closed for maximum efficiency in Cooling Mode.
The display will show the actual room temperature. All fan
speeds are available in this mode. Note: in Fan Only mode
the temperature cannot be adjusted.
When the unit is on or off press Timer button once and
the TIMER ON indicator will illuminate initiating the Auto
Start program.
Press the Timer button a second time and the TIMER OFF
indicator will illuminate initiating the Auto Stop program.
Press or hold the UP or DOWN buttons to set the time by
0.5 hour increments up to 10 hours, then in hour
increments up to 24 hours. The control will count down the
time remaining until the unit will turn on.
The selected time will register in 5 seconds and the system
will display the previously set temperature or room
temperature if the unit is turned on. (When the unit is off,
the display will not be lit.)
To cancel a timer manually turn the unit ON or OFF or
adjust the timer setting to 0.0.
In this mode the air conditioner will act as a dehumidifier.
Depending on the space, some degree of cooling will
continue.
Mode: