SPACE SAVING AM / FM CLOCK RADIO WITH DUAL ALARMS OWNER'S MANUAL CK5051 Visit our web site at www.emersonradio.com CK5051_ib_Rev.
W A R N IN G TO PREVENT FIRE OR SHOCK HAZARD, DO NOT USE THIS PLUG WITH AN EXTENSION CORD, RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES CAN BE FULLY INSERTED TO PRESENT BLADE EXPOSURE. TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. W AR N I N G RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER (OR BACK), NO USER SERVICEABLE PARTS INSIDE REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
Thank you for purchasing this Emerson Space Saving AM/FM Clock Radio with Dual Alarms. The bright green LED display is designed to be highly visible and easily readable from anywhere in your room. At the same time we have managed to minimize the cabinet size so that the radio won’t take up too much space on your night table. The dual alarms can be set and used independently.
IMPORTANT NOTES Avoid installing the unit in locations described below: • Places exposed to direct sunlight or close heat radiating appliances such as electric heaters. • Dusty places. • Places subject to constant vibration. • Humid or moist places. FCC INFORMATION This device complies with Part 15 of the FCC Rules.
PREPARATION FOR USE UNPACKING AND SET UP • Remove the radio from the carton and remove all packing material from the radio. We suggest that you save the packing material, if possible, in the unlikely event that your radio ever needs to be returned for service. The original carton and packing material is the only safe way to pack your radio to protect it from damage in transit. • Remove any descriptive labels or stickers on the front or top of the cabinet.
To install the battery: • Open the battery compartment cover on the bottom of the radio by pressing the tab in the direction of the arrow. • Connect the 9-volt battery to the battery terminal. It can only be connected one way. • Push the battery into the battery compartment and replace the cover. Press 9V OLT POWER FAILURE INDICATOR If no battery is installed in the radio, or if the battery in the compartment is weak or dead, the time and alarm settings will be lost if the power is interrupted.
LOCATION OF CONTROLS AND INDICATORS 20 1 2 3 21 4 5 6 7 8 15 16 17 18 12 9 13 10 11 14 22 19 Top Panel Right Side 1. ALARM 1 setting button. (ALARM RESET) 2. CLOCK setting button. 3. F. FWD (Fast Forward) button. 4. SLOW REV. (Slow Reverse) button. 5. ALARM 2 setting button. 6. RADIO ON button. 7. SLEEP button (Sleep to music timer). 8. SNOOZE /RADIO OFF(Sleep ‘Off’) button. Left Side 9. ALARM 1 selector switch. (RADIO/BUZZER/OFF) 10. ALARM 2 selector switch. (RADIO/BUZZER/OFF) 11.
OPERATING INSTRUCTIONS SETTING THE CLOCK When you connect the radio to your AC outlet for the first time the clock display will begin flashing “12:00” (AM). The flashing will stop when you set the time. button and advance the 1. Depress the Clock button and the Fast Forward display to a few minutes ahead of the correct time. AM indicator ALARM 1 indicator ALARM 2 indicator 2. Release the Fast Forward button and depress Slow Reverse until the correct time appears, then release all buttons.
CHECKING THE WAKE UP TIMES Whenever you want to check the wake up times, simply press either the Alarm 1 or Alarm 2 setting buttons. The display will change from correct time to wake up time. Release the Alarm 1 or Alarm 2 setting buttons to return to correct time. LISTENING TO THE RADIO 1. 2. 3. 4. 5. 6. Set the Band selector to the desired band, AM or FM. Set the Volume control to a low setting. Press the Radio On button to turn the radio ‘On’. Select your desired station with the Tuning control.
5. To stop the radio sooner, press the Alarm 1 (Alarm Reset) button. The radio will stop but the alarm remains set and will turn the radio on again at the same time on the following day. 6. If you do not want the alarm to turn the radio on the following day, set the appropriate Alarm selector to the ‘Off’position. WAKE TO BUZZER 1. Reconfirm the wake up time settings for the alarm you are using, Alarm 1, Alarm 2, or both alarms. 2. Set the Alarm selector switch for one or both alarms to the Buzzer position.
SLEEP TO MUSIC TIMER You can program the sleep timer to play the radio for up to 59 minutes and then shut off automatically. 1. Press the Sleep button. The display will briefly show “0:59” and the radio will begin to play. After 59 minutes the radio will shut off automatically. 2. To adjust the amount of time that the radio will play before shutting off, hold the Sleep button. The radio will begin counting down from “0:59”.
CARE AND MAINTENANCE There are no user serviceable parts inside this radio. Please refer all service problems to a qualified service facility. See the warranty page of this manual for further details. If the cabinet becomes dusty, wipe the exterior with a soft dust cloth only. Never use dusting sprays or polishes on the cabinet. If the cabinet becomes dirty or smudged with fingerprints it may be wiped with a soft cloth that has been slightly dampened with a mild soap and water solution.
LIMITED WARRANTY Emerson Radio Corp. warrants manufacturing defects in original material, including original parts and workmanship, under normal use and conditions, for a period of ninety (90) days from the date of original purchase in the U.S. With your dated proof of purchase, we will provide repair service at no charge for labor and parts at an authorized Depot Repair Facility, or replace the product in our discretion.
EMERSON RADIO CORP. EMERSON Part No. : 16-2840 112-01 800.898.9020 CK5051_ib_Rev.