AM/FM STEREO CLOCK RADIO COMPACT DISC PLAYER with DUAL ALARMS and NAP TIMER OWNER'S MANUAL CKD3630 Visit our web site at www.emersonradio.com CKD3630_060404.
CAUT I ON TO PREVENT FIRE OR SHOCK HAZARD, DO NOT USE THIS PLUG WITH AN EXTENSION CORD, RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE. TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
Thank you… … … … … … … for purchasing this Emerson Dual Alarm Stereo Clock Radio with CD Player, and Nap Timer. This compact sized unit has been designed to fit comfortably on any desk or bedside table. The CD Player has a 20-track programmable memory plus one-track/all tracks automatic repeat playback. The clock radio features a large, easily readable, 0.9” green LED display that is visible from anywhere in the room.
IMPORTANT NOTES • Avoid installing this unit in places exposed to direct sunlight or close to heat radiating appliances such as electric heaters, on top of other stereo equipment that radiates too much heat, places lacking ventilation or dusty areas, places subject to constant vibration and/ or humid or moist areas. • Operate controls and switches as described in the manual. • Before turning ‘On’ the power, make certain that power cord is properly installed.
PREPARATION FOR USE UNPACKING AND SET UP • Carefully remove the unit from the display carton. Remove all the packing material from the unit and remove any small strips of tape that may have been used to prevent the CD door from opening in transit. • Unwind and extend the FM lead wire antenna. • This unit was shipped with a dummy CD transit card in the CD player. This dummy CD prevents the laser pick up from moving during shipment. This card must be removed before you can insert your own CDs.
BATTERY BACK UP SYSTEM This model includes a battery back up circuit that will maintain the clock and alarm settings in the event of a temporary power interruption. The battery back up system requires one 9-Volt battery, not included. The battery compartment is located on the back of the cabinet. 1.) Press the battery door-locking tab in the direction of the arrow and remove the battery door. 2.) Connect a fresh 9-Volt alkaline battery to the battery terminal in the battery compartment.
POWER SOURCE This radio is designed to operate on 120V 60Hz AC only. Attempting to operate this radio on any other power source could cause damage to the unit and such damage is not covered by your warranty. Make sure the radio is connected to an AC outlet that is always “live”. Do not connect the radio to an outlet that is controlled by a wall switch. NOTE: This unit has a polarized AC plug with one wide blade and one narrow blade. This plug will only fit into a matching polarized AC outlet.
LOCATION OF CONTROLS AND INDICATORS FRONT PANEL 9 11 10 12 13 8 14 15 7 16 6 5 4 3 17 2 19 1 20 18 25 24 23 22 21 Button. 1.) PLAY/PAUSE 2.) SKIP REV. Button. 14.) LED Display. 3.) REPEAT Indicator. 16.) ALM (Alarm) 2 Indicator. 4.) POWER ‘On’Indicator. 17.) PLAY/PAUSE / FM ST. Indicator. 5.) SLEEP Indicator. 18.) PROG. (Program) Indicator. 6.) Radio Dial Scale. 19.) SKIP FWD. 7.) ALM (Alarm) 1 Indicator. 8.) AM Indicator. 20.) STOP Button. 21.) ALARM 1 Button. 9.
RIGHT SIDE PANEL 29 30 28 31 27 32 26 LEFT SIDE PANEL 35 34 36 33 37 26.) VOLUME Control. 33.) Back Up Battery Compartment. 27.) Function Selector Switch. 34.) Left Speaker. (CD/FM AUTO/AM) 35.) ALARM 1 Selector Switch. 28.) TUNING Control. (MUSIC/BUZZER/OFF) 29.) CD Door LIFT HERE tab. 36.) ALARM 2 Selector Switch. 30.) Right Speaker. (MUSIC/BUZZER/OFF) 31.) FM Lead Wire Antenna. 37.) DIMMER (HI/LO) Selector Switch. 32.) AC Power Cord. 8 CKD3630_060404.
OPERATING INSTRUCTIONS • Make sure you have installed the back-up battery in the battery compartment. • Make sure you have extended the FM Lead Wire Antenna to its full length. • Connect the AC power cord plug to a 120V 60Hz AC outlet. SETTING THE CLOCK When the radio is connected to the AC outlet for the first time the display will show flashing “12:00”. 1.) First depress and hold the TIME/DISPLAY button and then press the SKIP button or the SKIP REV. button to adjust the display forward or FWD.
SETTING THE WAKE-UP TIMES The procedure for setting the Alarm 1 and Alarm 2 wake up times is the same. 1.) First depress and hold the ALARM 1 button, then press the SKIP FWD. button or the SKIP REV. to adjust the display forward or back to the correct Alarm 1 wake-up time. The display will move slowly at first, and then begin to move rapidly. 2.) Be sure to set correctly for AM or PM. If the AM indicator is ‘On’, the wake-up time displayed is AM.
LISTENING TO THE RADIO 1.) Slide the function CD/FM AUTO/AM selector switch, located on the right side cabinet, to the FM AUTO or AM position. 2.) Press the POWER ON/OFF button on the top panel to turn the system ‘On’. The POWER indicator comes ‘On’. 3.) Tune to the desired station by slowly rotating the TUNING control on the right side. If you tune to an FM Stereo station the FM ST. indicator will come ‘On’.
PLAYING COMPACT DISCS IMPORTANT: This CD player can play normal CDs plus CD Recordable (CD-R) and CD Rewriteable (CD-RW) discs. However the playability of CD-R/RW discs may be affected by the type of software that was used in ‘ripping’ the tracks from the original discs and ‘burning’the tracks onto the blank media. Playability may also be affected by the quality and condition of the blank media you use for recording. 100% compatibility cannot be guaranteed.
5.) Press the PLAY/PAUSE button on the front panel to begin playback on track 1. FM ST. Track number “1” appears in the display and the PLAY/ PAUSE indicator comes ‘On’. After 5 seconds the display returns to the correct time. PLAY/PAUSE 6.) Adjust the VOLUME control to the desired level. 7.) Playback will continue until the last track has played then the disc stops and the PLAY/PAUSE indicator goes ‘Off’.
SKIP/Search ( / ) Controls During playback press the SKIP FWD. or SKIP REV. buttons on the front panel repeatedly to skip forward or back to higher or lower numbered tracks. Playback will start at the beginning of the selected track. To search within a track for a specific musical passage depress and hold the SKIP FWD. or SKIP REV. buttons on the front panel. The player will search rapidly forward or backward as long as the buttons are depressed.
SPECIAL PLAYBACK MODES REPEAT PLAYBACK You can program the player to continuously repeat a single track or the entire disc. The Repeat mode can be selected while the disc is playing or while the disc is stopped. Single Track Repeat Select the track to be repeated and then press the REPEAT button on the front panel once. The REPEAT indicator begins flashing. If necessary, press the PLAY/PAUSE button to begin playback. REPEAT The selected track will be repeated continuously.
PROGRAMMED PLAYBACK Use the Programmed Playback feature to play up to 20 tracks on a disc in any desired order. You may also program a particular track to play several times within a programmed sequence if desired. Note: You cannot program a disc while it is playing. Press the STOP button to stop playback and then follow the programming steps below. 1.) Load your disc as usual and wait until the display shows the total number of tracks on the disc. 2.) Press the PROGRAM button on the front panel.
5.) When you have completed programming the desired tracks press the PLAY/ PAUSE button to begin programmed playback. FM ST. The PLAY/PAUSE indicator comes ‘On’ and the PROG. indicator continues flashing. PROG. PLAY/PAUSE Playback will begin on the first track you programmed and will continue until the last programmed track has played. 6.) When the program is completed the player stops and the display again briefly shows the total tracks on the disc and then returns to the correct time.
ALARM FUNCTION You can use the alarm function to wake you to an electronic buzzer tone, the radio, or your favorite CD. First press the ALARM 1 or ALARM 2 buttons on the front panel to check the Wake Up time settings. Adjust the Wake Up times if necessary. Wake To Buzzer (Crescendo Alarm) Slide the ALARM 1 and/or ALARM 2 selector switches on the left side panel to the BUZZER position. The ALM 1 and or ALM 2 indicators appear in the display. At the selected wake up time the buzzer will sound.
Wake To CD IMPORTANT: This model includes an automatic default to the Buzzer alarm if the player cannot read the disc that you selected for wake-up. If the player cannot read the disc's Table of Contents (TOC) within 8 seconds, it assumes that the disc is either defective or inserted incorrectly, and the system automatically defaults to the Buzzer alarm to make sure that you wake up on time. The TOC of CD-RW discs may take longer to read than normal CD's.
SLEEP Timer You can fall asleep to the radio or CD player and the sleep timer will shut the system off automatically after up to 99 minutes of music. Sleep To Radio Set the function selector switch (CD/FM AUTO/AM) to the FM AUTO or AM position. Press the SLEEP button on the top panel. The SLEEP indicator comes ‘On’and the radio turns ‘On’. SLEEP POWER Select the desired station and volume level. The radio will shut off automatically after 30 minutes.
Adjusting The Length of The Sleep Timer The sleep timer default setting is 30 minutes but it can be adjusted downward or upward to a maximum of 99 minutes. Depress and hold the SLEEP button. The display will show “L:30” indicating that the power will shut off after 30 minutes. To adjust the sleep time continue holding the SLEEP button and depress the SKIP FWD. or SKIP REV. buttons on the front panel until the display shows the desired sleep timer length. Notes: 1.
NAP Timer (Buzzer Alarm Only) This model features a programmable 99-minute Nap Timer that can be used to wake you after naps of up to 99 minutes without disturbing your regular alarm settings. Depress and hold the NAP button on the top panel. The display shows “n:30”, indicating that the buzzer NAP alarm will sound in 30 minutes, and the NAP indicator appears in the display. To adjust the length of the Nap Timer continue holding the NAP button and depress the SKIP FWD. or SKIP REV.
LIMITED WARRANTY Emerson Radio Corp. warrants manufacturing defects in original material, including original parts and workmanship, under normal use and conditions, for a period of ninety (90) days from the date of original purchase in the U.S. With your dated proof of purchase, we will provide repair service at no charge for labor and parts at an authorized Depot Repair Facility, or replace the product in our discretion.
EMERSON Part No. 16-2958 406-01 CKD3630_060404.