Owner's manual

Playing Compact Discs

NOTE: Although the CD player can read CD-R and CD-RW discs, in addition

to normal CDs, however the playability of CD-R/RW discs may be affected by

the type of software that was used to create the discs, as well as the quality

and condition of the blank media you are using. 100% playability cannot be

guaranteed. This is not an indication of a problem with the player.

Normal Playback

1.) Press the POWER button to turn the system ‘On’. The Standby indicator

goes off.

2.) Press the FUNCTION button to select the CD

function. Two dashes (“– –”) flash in the display.

3.) Press on the CD door in the area marked OPEN/CLOSE to open the door. If

you haven't already done so remove the “dummy CD” transit protection card

from the CD player and discard it.

4.) Place your CD on the center spindle with the printed label side facing up and

close the CD door.

Two dashes (“– –”) flash in the display while the

player reads the disc and then the display shows

the total number of tracks on the disc.

NOTE: If the disc is inserted upside down, or if

the disc is badly scratched and unreadable, the

display will continue to show two dashes.

5.) Press the PLAY/PAUSE button to begin playback on track 01.

The play indicator appears.

6.) Adjust the VOLUME or control to the desired level.

7.) To skip to higher or lower numbered tracks press the or until the desired

track number appears in the display, then release the buttons. Playback will

begin on the desired track.

ES128_042806.p65 28/4/2006, 11:3918