Owner's manual

23
6.) Repeat Step 5 until you have stored up to 20 tracks in the CD program memory.
You may program the same track to play more than once if desired.
When you have fully loaded the memory with 20
tracks, two flashing dashes (“ – – “) will appear in
the track number display.
7.) Press the PLAY/PAUSE button to begin programmed playback.
The MEMORY indicator stops flashing and
remains ‘On’. The tracks that you selected will play
in the order in which they were programmed.
When the last programmed track has played the player stops and the display
again shows the total tracks on the disc. However, the program sequence
remains in the memory.
To play the program sequence again first press the PROGRAM/MEM./CLK. ADJ
button on the front panel or the PROG. button on the remote control, then
press the PLAY/PAUSE button.
8.) To clear the program sequence from the memory at any time, press
the STOP button to stop the disc if necessary, then first press the
PROGRAM/MEM./CLK. ADJ button, and press the STOP button once more.
The program sequence will also be cleared from the memory when you open
the CD door.
ES128_042806.p65 28/4/2006, 11:3923