User guide

Listening To The Radio

1.) Press the STANDBY/ON button to turn the system ‘On’.

The display lighting comes on and the display

briefly shows “HELLO”.

2.) Press the FUNCTION button to select the Tuner function.

An AM or FM frequency will appear on the

display.

Press the TUNER/BAND button again to

switch between the AM and FM bands if

necessary.

3.) Tune to the desired station as follows:

• Manual Tuning

Repeatedly press the SKIP/TUNING + or – buttons until the display shows the

exact frequency of the desired station. Use the Manual Tuning method to tune

to weak or distant stations that are not strong enough to be recognized by the

Automatic Tuning system.

• Automatic Tuning

Depress and hold the SKIP/TUNING + or – buttons until the display begins to

move, then release the buttons. The Tuner will search up or down the band for

the next strong signal and stop on that station. Repeat this procedure until the

tuner stops on your desired station.

4.) If you tuned to an FM Stereo station the ST

indicator will appear in the display. If the FM

Stereo reception is noisy or weak, press the

MODE button on the remote control to select

the FM Mono mode.

5.) Adjust the VOLUME, DBBS and EQ controls to the desired settings.

6.) When you are finished listening press the STANDBY/ON button to return the

system to the Standby (Off) mode. The display lighting goes off and the display

changes from radio frequency to correct time.

ES299_062905.p65 29/6/2005, 15:0719