Manual

Sensi Smart Thermostat | MANUAL OPERATION GUIDE 6
Setting the Time Manually
When connecting the thermostat to Wi-Fi, the time will sync automatically. If not
connecting to Wi-Fi, follow these steps to set the time at the thermostat.
1. Turn Wi-Fi Off. (Refer to section “Turn Wi-Fi Off” on page 4).
2. Press and hold the “Schedule” button.
3. The screen will go blank and the time will start flashing at the top. Use the up and down
arrow buttons to rotate through the times until you get to the appropriate time of day.
4. Press “Exit”.
Setting a Schedule
When connecting the thermostat to Wi-Fi, the schedule is
programmed based on time and temperature set points from the
Sensi app. If you are not connecting to Wi-Fi, follow these steps
to set a basic 7 day schedule with 4 mandatory set points.
(More robust scheduling options are only available through the Sensi app.)
1. Turn Wi-Fi Off. (Refer to section “Turn Wi-Fi Off” on page 4).
2. Use the “Mode” button to set which type of schedule it will be: Heat or Cool.
3. Press and hold the “Schedule” button, until you see the time flash at the top of the screen
a. Adjust the time on the thermostat if needed, using the up and down arrow buttons.
4. Press “Next”
5. You will see a large number in the middle of the screen. This refers to your set point.
a. The time will be flashing at the top of the screen. Adjust the time of
the first set point using the up and down arrow buttons.
b. Press “Next”. The set point will be flashing. Adjust the set
point using the up and down arrow buttons.
c. Press “Next”.
d. Repeat steps a-c for the second, third and fourth set points.
6. Press “Exit”.
7. Make sure “Schedule” is set to “On” on the thermostat.
MANUAL SETTINGS