User`s guide

A --- 1 Appendix
Controller Cover Removal
Hazardous voltage capable of causing shock,
burns, or death is connected to controller.
Deenergize all power before removing cover.
NOTICE
Touch ground first !
Electrostatic
sensitive device.
ATTENTION
Observe precautions for
handing electrostatic
sensitive devices.
The Group 5 controller (CP) is used for sensing, timing,
and control functions with 4000 & 7000 Series A utomatic
Transfer Switches. This Appendix shows the controller
DIP switch actuator settings and jumper block settings
for inpu t voltag e, frequenc y, phases, and type of transfer
switc h used (open , closed, delayed transition ). Th ese
controls should only be used by trained technicians from
A SCO Services, Inc. (ASI 1–800–800–2726).
DIP switch actuators see page A–2
Voltage jumper blocks see page A–4
press latches
(both sides)
cover with pocket
for manual & drawings
base w ith circuit
boards & membrane
controls
Figure A–1. Cover release latches.
Any indiscriminate change in DIP switch and jumper block set-
tings may damage the controller and/or cause an inoperative ATS.
Risk of explosion if battery is replaced by an incorrect type.
Dispose of used batteries according to local ordinances.