Surge Protection Brochure

Surge Protection

For Business-Critical Continuity

Liebert AccuGuide

High-Performance Interconnect Assemblies for

Systems with Parallel Surge Protection Devices

Interconnect made of conventional wire in conduit distributes

line power, but reduces the performance of surge suppressors.

The patented Liebert AccuGuide interconnect allows you

to get the most from your SPD by significantly reducing

clamping voltages.

Liebert AccuGuide interconnect assemblies can maximize

performance by transmitting transients generated by

lightning and switching with minimal voltage drops.

Each Liebert AccuGuide unit is an assembly of patented

coaxial cables. (One Liebert AccuGuide coaxial cable is

required for each protected mode.) Each cable minimizes

inductance (through reduced coaxial aspect ratios), and

features an extremely low impedance (2-10) unattainable

in conventional interconnect. As a result, the assembly

delivers practically the entire surge to the Surge Protection

Device (SPD). Clamping voltages are greatly reduced and

system performance is improved.

Liebert AccuGuide is designed to aid any installation.

This accessory is especially valuable in cases where the

SPD cannot be installed close to the point of protection

(greater than five feet). In conventional interconnect,

oltage loss increases with length — in excess of 16V/ft/kA

or an ANSI/IEEE, C62.41 combinations wave. In contrast,

ebert AccuGuide losses are under 4.2V/ft/kA for an

provement of 400%.

PAGE 1
Surge Protection For Business-Critical Continuity Liebert AccuGuide ® High-Performance Interconnect Assemblies for Systems with Parallel Surge Protection Devices Interconnect made of conventional wire in conduit distributes line power, but reduces the performance of surge suppressors. The patented Liebert AccuGuide interconnect allows you to get the most from your SPD by significantly reducing clamping voltages.
PAGE 2
Liebert Corporation Liebert AccuGuide Coax Construction Primary & Secondary Insulation Jacket Outer Braid Inner Braid Conductor Ordering Information: Liebert AccuGuide cable assemblies are available in several standard lengths for any service 1050 Dearborn Drive P.O. Box 29186 Columbus, Ohio 43229 800 877 9222 Phone (U.S. & Canada Only) 614 888 0246 Phone (Outside U.S.